- Replaced fuel injector seals ( Read more... )

- Lubricated speedometer cable with Lock-ease graphite solution ( Read more... )

Well, this most recent slave cylinder lasted just under 2 years. I went outside to check on some stuff in the engine bay in preparation for installing the MegaSquirt, and noticed that my clutch fluid was perilously low. An inspection of the engine bay and the ground beneath the vehicle revealed that some time last night (or the night before) my ( Read more... )

- Replaced foam strips on front portion of top door weatherstrip ( Read more... )

- Added a small amount of 134a refrigerant to the A/C system

The TX summer heat is beginning to kick in and the A/c has been feeling a bit anemic lately, so I hooked up the refill gauge and added a small amount of r134a to the system. It doesn't seem to be leaking as quickly as in previous years, so I'm hoping that it will be OK for a while.

- Inspected interior of car to see if there are any leaks around the new soft top (there were none apparent ( Read more... )

- Installed snaps on red deck carpet ( Read more... )

- Sprayed the snap vent with clear Plasti-Dip ( Read more... )

- Replaced strip caulk on bottom half of passenger side door moisture barrier with butyl tape ( Read more... )

- Replaced strip caulk on bottom half of driver side door moisture barrier with butyl tape ( Read more... )