How to Tie a Simple Shinju (breast harness)
Note: This is part 3 of an occasional ongoing "how to" series on rope bondage.
Part 1 of the series, How to Tie a Rope Harness Part I, is here.
Part 2 of the series, How to Tie a Frog Tie, is here.
As you might well imagine, none of these posts is even remotely work-safe.
In Japanese bondage (or "shibari"), a breast harness is called a "shinju." A shinju can be applied to just about any woman, though most shinju harnesses don't work well on men.
The style of shinju shown here is very simple, and easy to learn. More complex harnesses may have several layers of rope that cross the breasts directly, or vertical sections that are designed to press on and stimulate the nipples. This simple shinju can be used as a starting point for you to explore more complex forms of breast bondage, or can be tied beneath the karada demonstrated earlier.
So, without further ado, on to the tutorial!
Making a Simple Shinju
The shinju shown here can be made in only a few minutes. Many people prefer relatively short (20') lengths of rope for making a shinju; the rope I'm using here is longer than that, though it makes little difference. As with the karada, I prefer using longer pieces of rope with a shinju because I can then integrate the extra rope into other kinds of ties, such as arm ties.
As with a karada, you'll start your shinju by locating the middle of the rope. Place your finger on your partner's spine at about the level of the bottom of her breasts, hold the center of the rope there, and then pass it around your partner's torso. When you come all the way around, put the ends of the rope through the loop, then bring one side up over each shoulder, as these pictures show:
When you've done this, you'll have a piece of rope going around your partner just below the breasts, and two pieces of rope anging over her shoulders, as the first part of the picture below illustrates. Run the two ends of the rope beneath the part of the rope passing under her breasts, then bring them up over her shoulders again, like so:
At this point, you'll have two pieces of rope hanging down your partner's back. Take them both in your hand. Put your finger on your partner's spine, at a level just above the top of her breasts, and pull both pieces of rope together around her body above her breasts, like you see in the first picture here. Loop both pieces of rope through the loop you made with your finger; it'll make sense when you do it, I promise.
Now you're almost finished. Take the two pieces of rope that are hanging down, and pass them under the lower piece of rope that goes around your partner's torso. Then just wrap the ends of the rope around and around, like you did with the karada.
When you're done, the shinju should look like this from the front:
There are all sorts of things you can do from this point, especially if you're using a 20' or 25' length of rope rather than a shorter length.
For example, you can use the ends of the rope hanging down your partner's back to tie her arms behind her back, which will cause your partner to arch her back and display her breasts quite nicely. Or, if you like, rather than wrapping the ends of the rope around the lower of the two parts going around her torso, wrap the ends of the rope around both the upper and lower parts around her torso. This causes the upper and lower rope to squeeze together, stimulating the breasts.
You can bring a third wrap around the center of her breasts, directly across the nipples, which will constantly stimulate her nipples, especially whenever she moves.
When you bind your partner's breasts in a shinju, you can then tie the back of the shinju to a fixed upright object such as a post, which will hold her in place and allow you to caress, stimulate, or even flog her breasts. (If you flog the breasts of a person bound in this way, be aware that the rope will prevent the breasts from moving the way they would if she wasn't bound, so you should take care to do so more gently than you would otherwise.)
The shinju can be used as a foundation, with a karada tied over it. or the upper parts of the arms can be bound to the two ropes that pass around the person's torso, holding the arms at the side. Experiment, and you'll find all kinds of variations that start with this basic tie.
Part 1 of the series, How to Tie a Rope Harness Part I, is here.
Part 2 of the series, How to Tie a Frog Tie, is here.
As you might well imagine, none of these posts is even remotely work-safe.
In Japanese bondage (or "shibari"), a breast harness is called a "shinju." A shinju can be applied to just about any woman, though most shinju harnesses don't work well on men.
The style of shinju shown here is very simple, and easy to learn. More complex harnesses may have several layers of rope that cross the breasts directly, or vertical sections that are designed to press on and stimulate the nipples. This simple shinju can be used as a starting point for you to explore more complex forms of breast bondage, or can be tied beneath the karada demonstrated earlier.
So, without further ado, on to the tutorial!
Making a Simple Shinju
The shinju shown here can be made in only a few minutes. Many people prefer relatively short (20') lengths of rope for making a shinju; the rope I'm using here is longer than that, though it makes little difference. As with the karada, I prefer using longer pieces of rope with a shinju because I can then integrate the extra rope into other kinds of ties, such as arm ties.
As with a karada, you'll start your shinju by locating the middle of the rope. Place your finger on your partner's spine at about the level of the bottom of her breasts, hold the center of the rope there, and then pass it around your partner's torso. When you come all the way around, put the ends of the rope through the loop, then bring one side up over each shoulder, as these pictures show:
When you've done this, you'll have a piece of rope going around your partner just below the breasts, and two pieces of rope anging over her shoulders, as the first part of the picture below illustrates. Run the two ends of the rope beneath the part of the rope passing under her breasts, then bring them up over her shoulders again, like so:
At this point, you'll have two pieces of rope hanging down your partner's back. Take them both in your hand. Put your finger on your partner's spine, at a level just above the top of her breasts, and pull both pieces of rope together around her body above her breasts, like you see in the first picture here. Loop both pieces of rope through the loop you made with your finger; it'll make sense when you do it, I promise.
Now you're almost finished. Take the two pieces of rope that are hanging down, and pass them under the lower piece of rope that goes around your partner's torso. Then just wrap the ends of the rope around and around, like you did with the karada.
When you're done, the shinju should look like this from the front:
There are all sorts of things you can do from this point, especially if you're using a 20' or 25' length of rope rather than a shorter length.
For example, you can use the ends of the rope hanging down your partner's back to tie her arms behind her back, which will cause your partner to arch her back and display her breasts quite nicely. Or, if you like, rather than wrapping the ends of the rope around the lower of the two parts going around her torso, wrap the ends of the rope around both the upper and lower parts around her torso. This causes the upper and lower rope to squeeze together, stimulating the breasts.
You can bring a third wrap around the center of her breasts, directly across the nipples, which will constantly stimulate her nipples, especially whenever she moves.
When you bind your partner's breasts in a shinju, you can then tie the back of the shinju to a fixed upright object such as a post, which will hold her in place and allow you to caress, stimulate, or even flog her breasts. (If you flog the breasts of a person bound in this way, be aware that the rope will prevent the breasts from moving the way they would if she wasn't bound, so you should take care to do so more gently than you would otherwise.)
The shinju can be used as a foundation, with a karada tied over it. or the upper parts of the arms can be bound to the two ropes that pass around the person's torso, holding the arms at the side. Experiment, and you'll find all kinds of variations that start with this basic tie.