Pointers: *Run crosstalk simulations *Place power planes in between signal planes *Measure the wires lengths *Pray? *Talk to Linderman... he'll have some pointers *Read "High-Speed Digital Design-A Handbook of Black Magic" or some similar book that is more related to what you are doing. But that's a pretty good book... depending on what you are doing, Mike might point you towards the same thing.
All I remember is that electrons do get confused running around corners if you make them do it too fast or too often. They start running into the wall or something.
Uh, I finished the board a week ago... but I wanted to respond to your comments. I can terminate the lines because they're analog RF lines and their magnitude is rather important. I had to do some impedance matching (75 and 50 ohm lines) to prevent reflections... And it was only a two layer board, so no power/ground planes.
Yo, I am going to a "White Trash X-mas" on saturday...if you wanna go, lemme know. All you gotta do is dress like trash and bring a 40. Should be really awesome.
Comments 8
Reply
*Run crosstalk simulations
*Place power planes in between signal planes
*Measure the wires lengths
*Pray?
*Talk to Linderman... he'll have some pointers
*Read "High-Speed Digital Design-A Handbook of Black Magic" or some similar book that is more related to what you are doing. But that's a pretty good book... depending on what you are doing, Mike might point you towards the same thing.
Reply
Reply
Reply
Reply
Reply
Reply
Reply
Leave a comment