Собранные на скорую руку ошибки UPTool.
Практического смысла немного (логи UPTool вполне информативны), но возможно, кому-то поможет
0070h Err at Setup Parameters For IB-Table
0051h Downgrade Flash, but not found IB-Table
0052h Bad Column is not paired.
0061h Diff of controllers in F/W & ROM
0073h Not Support Controller
0075h MBC Page is not enough for CK/IB
0075h MBC Page is not enough for no CK MBC IB
0078h Enhance Ecc mode sorting , but used not support FW. Please new FW
0082h Cannot get ISP version
0082h Err at install ISP
0082h Burner ISP read fail
0082h ISP allocate buffer fail
0082h ISP file not found
0082h ISP file too small
0084h Flash Reset Fail
0085h D1 Source Block Need:%d > D1 Source Block Have:%d
0091h NewSort_eD3_CopyBack_2Slot
0101h FSlot-%d, Flash ID fail
0990h Fail to init Bad Column
1106h Burner ISP allocate buffer fail
1106h Burner ISP file not found
1106h Burner ISP file too small
1106h Burner ISP read fail
1106h Cannot get burner version
1106h Cannot get ISP version
1106h Cannot Install burner ISP code
1106h Cannot Install burner ISP code
1106h ISP file not found
1107h Could not store CP to Bad-Block
1107h F/W allocate buffer fail
1107h F/W ISP file too small
1107h F/W ISP read fail
1107h Find CZ-Block fail, no more good block
1107h unknown error, CZ page could not be located
110Fh Too few CodePage
1120h Err at Burner to JUMP
1122h Burner load IB-Table
1123 Fail to get CZ from Burner
1124h F/W Code file not found
1125h Err at Jump to ISP
1199h 67BC: Good block for CP Over Search Rule
6019h Disk is still in ROM stage
Начало