Тёпленькая не пройдёт!

[lx_photos]

Как уже известно, самолёт со льдом летает не то чтобы хорошо. Просто иногда только вниз.
И пока на дворе в дрова, нам с вами можно в тепле подготовиться к неизбежной зиме. Поэтому сегодня рассмотрим противообледенительное отопление крыла Airbus-320.

Comments

[lx_photos]

По сообщению на дисплее и по загоранию лампы Fault в кнопке.

Несоответствие положения заслонки требуемому, или давление не в требуемых пределах.

There is a 15 second delay before the warning messages show on the ECAM system. This prevents warnings that are not necessary because of low pressure when the system is set to ON.

When the system is set to ON, the FAULT light comes on until the pressure is above the low limit.

(1) System set to OFF and the control valve is not closed (aircraft on the ground)
After the aircraft has landed and if the control valve does not close within 35 seconds, the system gives:
-an amber warning
-a single chime
-a warning on the ECAM to tell the flight crew to turn off the system to prevent overheat damage.

(2) System set to OFF and the control valve is not closed (in flight)
If the control valve does not close (with the system set to OFF) in flight, the system gives:
-an amber warning
-a single chime
-an ECAM warning.
The warning is inhibited during take-off (from a ground speed of 80kts to an altitude of 1,500ft) and landing (from an altitude of 800ft to a ground speed of 80kts).

(3) System set to the ON position and the control valve is closed.
If one of the two or the two control valve(s) does/do not open (when the system is set to ON) within 15 seconds, the system gives:
-an amber warning
-a single chime
-data shown on the ECAM related to the position of the engine bleed valve(s) and the cross-bleed valve.
The FAULT (amber) light on the P/BSW (3DL) will come on.

(4) System set to the ON position and the pressure is not in limits.
When the system is set to the ON position and the pressure is too high (for a period in excess of 40 seconds), the system gives:
-the applicable ECAM warning(s).
The FAULT (amber) light on the P/BSW will not come on.

When the system is set to the ON position and the pressure is too low (for a period in excess of 15 seconds), the system gives:
-an amber warning
-a single chime
-the applicable ECAM warning(s) related to the position of the engine bleed valve and the cross-bleed valve.

The FAULT (amber) light on the P/BSW (3DL) will come on.

[ext_995878]

Спасибо!
Доходчиво))