Learning new to science
I have discovered a new thing:
When drilling through two bits of thin brass, holding them together to make sure the holes line up properly, one should not have any of the holding fingers under where the drill is going to come out.
Even when that is on the far side of the wooden benchpeg, up at the end where the drill will go through it in half a second and continue into unresisting fingertip.
When drilling through two bits of thin brass, holding them together to make sure the holes line up properly, one should not have any of the holding fingers under where the drill is going to come out.
Even when that is on the far side of the wooden benchpeg, up at the end where the drill will go through it in half a second and continue into unresisting fingertip.